Product Categories
Product Search

 
Wireless Gaming Headphones 返回上一页



JYS Wireless Gaming Headphones with Mic &3.5mm Audio Transmitter

for Nintendo Switch | PC | Cell phone


 Part Names  


(1)Volume-/PREV                                   (7)Charging light/Pairing light

(2)Pairing/Phone/Play/Pause                   (8)Microphone

(3)Volume+/NEXT                                 (9)Network indicator  
(4)Power-on/Power-off/Networking         (10)Charging indicator
(5)Micro USB Charging Port                    (11)Power on/Networking

(6)AUX IN Port                                     (12)Micro USB Charging Port




Wireless headphone   



Input DC 5V  500mA
Battery specification 3.7V 500mAh 
Charging Time 1.5 hours(depending on battery level)
Battery life theoretically 5 hours for 400mAh
Frequency response 20Hz-20KHz
Drive unit/diameter 32Ω/40mm
Wireless standard Bluetooth V.4.2 Broadcast networking
Operating frequency 2.402-2.480GHz
Lag between transmitter and headphone ≤40mS
Transmission distance ≥10m

Charging indicator

 

After insertion of USB the red light flashes once every 1s
When fully charged the red light always on. After pulling out 
USB, the red light goes out

 

 

Low battery

 

 When battery lower than 3.5V  the red light flash 3 times every 3s
 When battery lower than 3.4V  headphone auto power-off with
prompt tone

 

 

Turning on/Turning off

 

 Short-press button 4 [Power-on/Power-off] to turn on. Long-press to turn off when power on. Both have prompt tone.

Wireless transmitter      

 

Input  DC 5V  500mA
Battery specification  3.7V 300mAh 
Charging Time  1.5 hours(depending on battery level)
Battery life  theoretically 5 hours for 400mAh
Operating frequency  2.402-2.480GHz
 Lag between transmitter and headphone  ≤40mS
 Transmission distance  ≥10m

 

 

 Charging indicator

 

After insertion of USB the red light flashes once every 1s
When fully charged the red light always on. After pulling out 
USB, the red light goes out

 

Low battery

 

When battery lower than 3.5V the red light flash 3 times every 3s
When battery lower than 3.4V Transmitter auto power-off, headphone 
auto power-off at the same time.

 

 Turning on/Turning off

 

When power on, long-press button 12 to turn off

*the connected Wireless headphone will power off at the same time.

*The transmitter will automatically shut-down if no headphone connected within 3 minutes.

 

 

     Networking Mode     

 

 

 How to connect headphone with transmitter  

 

1,Short-press button 4 for 4 seconds to turn on Wireless headphone

2,Short-press button 12 for 4 seconds to turn on Wireless transmitter  

3,Short-press button 12 of Transmitter twice to enter into pairing 
status(blue light flash once every 0.5s)

4,Short-press button 4 of Headphone twice to start searching mode
(blue light flash once every 0.5s)

5,The indicator keeps blue if connected successfully.

6,Your Headphone and Transmitter is now ready to use,you can 
inset it in Switch or other device’s 3.5mm stereo headset jack

 

How to enter into reconnection mode

 

If your headphone with transmitter has been connected

 

1,Short-press button 4 for 4 seconds to turn on Wireless headphone

2,Short-press button 12 for 4 seconds to turn on Wireless transmitter

3, Headphone and Transmitter will enter into reconnection mode 
(blue light flash once every 3s),The reconnection last for 1 min

4,The indicator keeps blue if connected successfully

 

 Tips:

When use transmitter on PS4 Controller,you should go into Settings,enable out to headphones all audio

 

Settings→Devices→Audio Devices→Output to headphones→All Audio

 

 

     Other modes for Wireless Headphone       

 

Except Nintendo Switch or other device with 3.5mm stereo headset 
jack,you can also use your Headphone separately with other devices 
with bluetooth function.

 

Bluetooth mode

After power on, long-press button 2 for 2s to enter Bluetooth mode with prompt tone(when not in Line in mode). If hasn’t connected to other device before,it enter pairing mode with prompt tone. If has connected to other device before, enter reconnect mode,reconnection time is 15s. Green light always on when succeed,enter pairing mode when fail. If no connection for 3 min, auto

power-off with prompt tone.




Pairing mode Green light flash once every 0.5s 
Reconnection mode Green light flash once every 3s
Bluetooth establishment succeed Green light always on.

 

 

 Note:In A2DP mode, short-press button 4 for Play/Pause When connected to cell phone and a call come, shot-press button 2 to pick up, long-press to reject the call. In call status, Long-press 
button 2 to switch the voice between headphone and cellphone. Shot-press button 2 to hang up.

 

In bluetooth mode:

Push up button 1 once for Volume-,twice for last song; 
Pull down button 3 once for Volume+,twice for next song.

 

Line in mode

 

Line in function only available when Power on. After insertion of Line in cable, regardless it is in network mode or Bluetooth mode, it will enter Line mode. Green light flash once every 3s, 
Network mode or Bluetooth mode will paused but not exit. Only Voice of Line in can be heard. Green light and blue light both always on. Pull out Line in cable, it return to network mode 
or Bluetooth mode. If detected insertion of line in cable when turning on, it will enter line in mode automatically.



脚注信息
 Copyright(C)2015-2017 JinYuanSheng
脚注栏目